The demand for AUMA electric actuators is constantly increasing, and many places are inseparable from it. In order to let you buy good quality products, next we will tell you about some relevant knowledge points of hot melt gaskets. There may be a lot of people do not know it, then the following Xiaobian will tell you about it, I hope to help you.

AUMA electric actuators are widely used in many fields, which I believe you should also know. But now the domestic production of manufacturers is really very much, you just go to the Internet search will be a lot. In fact, the AUMA electric actuator in the process technology site, liquid, gas, steam and particles need to pass through the pipeline. Flow is controlled by opening and closing valves to restrain or release pipe media. AUMA actuators are controlled remotely from the control room to operate industrial valves. This is really a good way to implement straight stroke operation. For example, when a globe valve is used, the linear thrust unit Le can be mounted on a multi-turn actuator SA to form an electric direct-stroke actuator. When operating the damper is required, the linear thrust unit can be mounted directly on the base. AUMA electric actuators are usually used for local control and remote control, because their motor power is relatively large, up to tens of kilowatts. These three types of actuators are positional servomechanisms driven by two-phase AC motors. The electrical principle of these three retarders is exactly the same, but the retarders are different. It is mainly composed of servo amplifier and actuator. The operator can be in the middle in the middle. The servo amplifier receives the control signal sent by the controller and compares it with the feedback signal of the output displacement of the electric actuator.

If there is a deviation, the difference will drive the two-phase servo motor to rotate after power amplification. Of course, our products can still meet these requirements. We also welcome friends from all over the country to come here to establish long-term cooperative relations. After all, it is well known in the industry, reasonably priced and guaranteed in quality. You won't be disappointed. AUMA electric actuator is mainly used for butterfly valve control. The straight-travel actuator is actually a combination of a multi-rotation actuator (SA) and a linear thrust device (LE). It controls the valve mainly by pushing and pulling! In fact, the AUMA electric actuator launched today is widely used in power, petrochemical, metallurgy, textile, water conservancy, sewage treatment, building materials and other industrial and civil fields! The reducer then slows down the AUMA electric actuator to drive the output shaft to change the Angle. If the difference is positive, the servo motor rotates forward and the output shaft Angle increases. If the difference is negative, the servo motor reverses and the output shaft Angle decreases. When the difference is zero, the servo amplifier outputs a contact signal to stop the motor. At this time, the output axis is stable at the Angle corresponding to the input signal. This position feedback structure can make the linear relationship between the input current and the output displacement better. In addition, it not only works with the controller to achieve automatic control, but also allows the operator to switch between automatic and manual control of the control system. When the operator's transfer switch is placed in the manual operation position, the forward and reverse operation buttons directly control the power supply of the motor to achieve the forward or reverse rotation of the actuator output shaft for remote control of manual operation.