Today, this article mainly introduces the basic information of AUMA electric actuator for you, because there are many knowledge points that we need to understand before using this product, and I believe that most people do not understand this part of the content. As a manufacturer, we use this opportunity to share for our friends today, if you are interested, you can read it together, hoping to bring help to relevant people.

With the continuous development of science and technology, now the products used by AUMA electric actuators are also more and more, and after continuous improvement and improvement, all aspects have been improved. AUMA electric actuators are compact and compact in size. Compared with pneumatic actuators, electric actuators are relatively simple in structure. A basic electronic system consists of actuators, three-position DPDT switches, fuses, and some wires, which are easy to assemble. In particular, the drive source of the electric actuator of this product is very flexible. The general on-board power supply can meet the demand, and the pneumatic actuator needs an air source and a compression drive device. There is no "leakage" danger, high reliability, and the compressibility of air makes the stability of the pneumatic actuator slightly worse. Therefore, there is no need to install and maintain various pneumatic pipelines at this time. Of course, it can also maintain the load without power, while the AUMA electric actuator requires a constant pressure supply. Electric actuators are quieter because no additional pressure devices are required. Under normal circumstances, if the pneumatic actuator load is large, then add ***. The control accuracy of electric actuators is higher. Of course, the pneumatic device of the product that we say today usually needs to convert the electrical signal into a gas signal and then into an electrical signal, and the transmission speed is slow, and it is not suitable for complex circuits with too many components in series.

When using this AUMA electric actuator it is very stable and the user can apply constant thrust. The actuator can produce thrust up to 225,000 KGF. Only hydraulic actuators can achieve such a large thrust, but the cost of hydraulic actuators is much higher than that of electric actuators. Except for what we said for you. In fact, its anti-deviation ability is very good, especially when in use, its output thrust or torque is basically constant, which can well overcome the unbalanced force of the medium and achieve accurate control of process parameters, so the control accuracy is higher than that of the pneumatic actuator. If equipped with a servo amplifier, the AUMA electric actuator can easily achieve the exchange of positive and negative effects, but also can easily set the shutdown signal valve position state (hold/full on/full off), in case of failure, to remain in the original position, which is not possible for pneumatic actuators. The pneumatic actuator achieves position retention with the help of a combined protection system. Once the type of electric actuator and the required drive torque of the valve are determined, the selection can be made using the data sheet or selection software provided by the manufacturer of the AUMA electric actuator. Sometimes it is necessary to consider the speed and frequency of valve operation.

The content of the above article is some basic information about the advantages of this AUMA electric actuator introduced by Xiaobian. If you don't know it before, you can read it carefully now. The next installment will bring more wonderful content.